A New Battery Charging System with Redundant, Easily Replaced Charge Modules Providing High Reliability and Serviceability
NewMar PT-24-8 Battery Charger Reliability: ¨ Redundant, independent, charger modules increase reliability - a malfunction of one does not disable the charging system; remaining modules continue to operate.
NewMar PT-24-8 Battery Charger Serviceability: ¨ Module change-out takes only minutes, while the system continues to operate ¨ Technical personnel not required ¨ No need to remove the charger case from the boat or disconnect any wiring ¨ No inconvenience of power interruption to the boat
NewMar PT-24-8 Battery Charger Features: ¨ Three stage ¨smart¨ charging; bulk, absorption, float ¨ Battery type selector switch; gel-cell, lead-acid, AGM ¨ Temperature compensated output option ¨ Numerous diagnostic and system status indicators ¨ 12 Volt; 33-100 amps or 24 Volt; 22-67 amps ¨ ¨Universal¨ input of 90-264 VAC, 50-60 Hz.¨can be used anywhere in the world ¨ Powder coated stainless steel case
NewMar PT-24-8 Battery Charger HD Video Playlist:
Captains and owners will appreciate this system approach to reliability. A dead charger and dead batteries can disable a vessel, but with the NewMar redundant charging system a fault in one of the modules is easily identified and it can be quickly replaced with an on-hand spare or an exchange unit from the factory, while the charging system continues to operate. The NewMar PT-24-8 Battery Charger features three stage charging for rapid recharge and optimal battery life.
NewMar PT-24-8 Battery Charger General System Specifications: Input Voltage/Frequency: 90-264 VAC, 47-63 Hz, single phase; derate linearly from 100% output @ 105 VAC to 80% output @ 90 VAC Power Factor: .96-.99 Efficiency: 85% typical Nominal Charge/Float Voltages: Refer to chart below Temperature Compensation (Option): - 5 mV per cell per øC (typical) Temperature Rating: 0-60ø C; derate linearly from 100% output @ 50ø C to 80% output @ 60ø C Recommended Battery Type/Capacity: Gel-Cell, Flooded or Sealed Lead-Acid; 12 Volt Systems: 6 Cell, 80-400 A-H (per installed module); 240-1200 A-H (per system) 24 Volt Systems: 12 Cell, 40-200 A-H (per installed module); 120-600 A-H (per system) Output Battery Banks: 3 Module Bays: 3* Status Indicators: Output OK, No Output, Check System, Battery Too Hot, Total Output Bar Graph, Output Voltage Test Points, Contacts for Optional Remote Alarm Case Material: Powder Coated Stainless Steel Case Size: Refer to diagram at right Weight: Empty: 16 lbs/7.3 kg. - With three modules installed: 34 lbs/15.5 kg. * Note: Charge modules are shipped in the same carton as the PTM case and are then placed in position by the installer.
NewMar PT-24-8 Battery Charger Voltage Specifications:
Sign In
